1. In the Discover/Define Configuration panel, choose 3 Path Set Definitions.
The Path Set Selection List panel displays.
2. Specify e in the AC column that corresponds to the ID of the path set to which you want to
add the logical path.
3. Press the Enter key.
The path set definition file is loaded and the Path Set Detail panel displays.
4. Press the F5=Add key.
The Edit Logical Path Definition panel displays.
5. Specify CU for Type.
6. For SHR, specify Y when sharing the target path with other logical path definitions, specify N
for not sharing the target path.
If you do not specify anything, N is assumed.
7. Specify s in the AC column on the Primary line.
448 Using the ISPF panels
To Next Page
Loading...
