Figure 119 Definition example of a copy group that is not a copy group container
Before you define a copy group, make sure that you decide on values for the following:
• DAD ID for the primary site and the secondary site
The examples in this section use the following values:
◦ For the primary site: DADP
◦ For the secondary site: DADS
• Prefix for the configuration file name
For details, see “Setting a prefix for configuration files” (page 102).
Defining the copy group ID and copy group attributes (Cnt Ac-J Z)
To define a copy group:
1. Display the Discover/Define Configuration panel and choose 4 Copy Group Definitions.
The Copy Group Selection List panel displays.
2. Press the F5=Add key to add a Cnt Ac-J Z copy group.
The Add Copy Group panel displays.
3. Specify the Copy Group ID, Primary Device Address Domain, Secondary Device Address
Domain, and Copy Group Type (Cnt Ac-J Z).
If this is a copy group container definition, specify / for Use Container. If this is not a copy
group container, leave Use Container blank.
478 Using the ISPF panels
To Next Page
Loading...
