4. Press the Enter key.
The Setting C/T ID Attributes panel appears.
5. Specify C/T ID (JNLG) and Sub C/T ID (JNLG).
6. Press the Enter key.
The Copy Group Pair Detail panel appears (in the initial status, no display line appears).
7. Press the F4=Attr key.
The Copy Group Attributes (Cnt Ac-J Z) panel appears.
8. Specify copy group attributes (such as PROT MODE).
Be sure to leave Mirror ID set to 1.
9. Press the Enter key.
The Copy Group Pair Detail panel appears.
Defining a copy group 479
To Next Page
Loading...
