HP XP P9500

Defining the inter-CU logical path set..................................................................................447
Adding a logical path to path set..................................................................................447
Allocating physical paths to logical paths.......................................................................452
Establishing a logical path.....................................................................................................456
Defining a route list...............................................................................................................457
Defining a route list ID......................................................................................................458
Defining the first entry of the route......................................................................................459
Adding an entry (extended route definition).........................................................................463
If the storage system on the secondary site has been scanned...........................................464
Remote scanning of the Storage System on the secondary site from the primary site.............466
Defining the second route.................................................................................................468
Images for route list definitions...........................................................................................468
Registering a command device in a Storage System..................................................................470
Remote scan procedure.........................................................................................................472
Specifying a route list ID...................................................................................................472
Performing a remote scan..................................................................................................473
Assigning a dummy device number....................................................................................474
Changing dummy device numbers.....................................................................................477
Defining a copy group..........................................................................................................477
Defining the copy group ID and copy group attributes (Cnt Ac-J Z).........................................478
Adding the copy pair to the copy group (Cnt Ac-J Z)........................................................480
Defining the copy group ID and copy group attributes (BC)...................................................482
Adding the copy pair to the copy group (BC)..................................................................483
Defining the copy group ID and copy group attributes (CA)...................................................483
Adding the copy pair to the copy group (CA).................................................................484
Defining the copy group ID and copy group attributes (Cnt Ac-A)...........................................484
Adding the copy pair to the copy group (Cnt Ac-A).........................................................485
Defining a copy group container............................................................................................485
Defining the copy group ID and copy group attributes..........................................................486
Adding a C/T group........................................................................................................487
Changing a copy group that is not a copy group container to one that is (adding a C/T
group)............................................................................................................................488
Changing a copy group that is a container to one that is not (deleting a C/T group)................489
Defining an EXCTG..........................................................................................................489
Saving settings................................................................................................................492
Defining an Open/MF consistency group................................................................................492
Loading a copy group......................................................................................................493
Suspending a copy group.................................................................................................494
Changing a copy group definition (setting the Open/MF Consistency attribute).......................495
Loading a copy group after changing its definition...............................................................496
Resynchronizing a copy group...........................................................................................497
Operating copy groups.........................................................................................................500
Loading a copy group......................................................................................................501
Making a Cnt-Ac J Z copy pair (SIMPLEX to DUPLEX)............................................................503
Suspending a Cnt-Ac J Z copy pair....................................................................................507
Making a Business Copy for Mainframe copy pair (SIMPLEX to DUPLEX).................................508
Suspending a Business Copy for Mainframe copy pair.........................................................510
Resynchronizing a Cnt-Ac J Zcopy pair...............................................................................511
10 Automatic operation using BCM Monitor.................................................513
Overview of the Business Continuity Manager Monitor functions.................................................513
Business Continuity Manager Monitor operator commands....................................................516
The monitoring status of a copy group................................................................................517
Putting Business Continuity Manager Monitor to sleep...........................................................517
Stop point.......................................................................................................................517
12 Contents