EasyManuals Logo

HP XP P9500 User Manual

HP XP P9500
608 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Function That Monitors Event and Errors.....................................................................................98
4 Preparing to use Business Continuity Manager.............................................99
Preparation overview..............................................................................................................99
Specifying the Business Continuity Manager Log output destination.............................................100
Setting up Storage Systems....................................................................................................100
Settings in the Set Defaults panel............................................................................................101
Specifying the Device Address Domain ID...........................................................................101
Setting a prefix for configuration files..................................................................................102
Creating configuration files....................................................................................................102
Overview of configuration files..........................................................................................102
Required settings for configuration files...............................................................................105
Preparing the configuration files on each site.......................................................................105
Acquiring volume information (preparations)............................................................................106
Performing a local scan to acquire volume information..........................................................106
Performing an NG Scan (on a Non-Gen'ed Volume) to acquire device configuration
information.....................................................................................................................106
Preparing the hardware (NG Scan)...............................................................................106
Preparing the configuration files (NG Scan)....................................................................107
Performing a remote scan to acquire remote storage system information..................................107
Specifying a Route List ID.............................................................................................109
Performing a Remote Scan............................................................................................110
Assigning a Dummy Device Number..............................................................................110
Creating a logical path.........................................................................................................111
Establishing a logical path................................................................................................112
Establishing an Inter-Control Unit logical path......................................................................113
Acquiring path information from a storage system................................................................113
Checking the Prerequisite Conditions for Acquiring a Port Number....................................114
Establishing a logical path in the reverse direction................................................................115
Deleting a logical path.....................................................................................................115
Setting up the Remote DKC Control Function environment...........................................................115
Configuring routes...........................................................................................................116
Procedures for configuring routes...................................................................................116
Example of configuring routes.......................................................................................117
Defining the route list........................................................................................................118
Route List Settings........................................................................................................119
Registering a command device..........................................................................................119
Registering a command device in the forward direction....................................................119
Command device setup procedure.................................................................................119
Registering a command device in the reverse direction.....................................................120
Command device definition rules...................................................................................120
Deleting command devices................................................................................................120
Deleting Command Devices Registered in a Route List......................................................121
Deleting Command Devices Not Registered in a Route List................................................121
Creating an Inter-Control Unit Logical Path dedicated to the command device..........................122
Supporting a Cnt Ac-S Z or Cnt Ac-A Z copy group configuration......................................122
Supporting a Continuous Access Journal for Mainframe copy group configuration...............123
Preparing to use the Remote DKC Control function................................................................123
Configuration definition for using the Continuous Access Synchronous Consistency Preservation
function...............................................................................................................................123
Defining a copy group.....................................................................................................124
Environment definition for using the Reverse Resync function.......................................................124
When the Reverse Resync function is used from the primary site and one or more other sites......125
When the Reverse Resync function is used only from the primary site.......................................125
Contents 5

Table of Contents

Other manuals for HP XP P9500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP XP P9500 and is the answer not in the manual?

HP XP P9500 Specifications

General IconGeneral
BrandHP
ModelXP P9500
CategorySoftware
LanguageEnglish

Related product manuals