HPE Cloudline CL3100 Gen10 - Page 110

Software and configuration utilities 110
Setup Item
Options
Help Text
Comments
Stop Bits
1
2
Stop bits indicate the end of a
serial data packet. (A start bit
indicates the beginning). The
standard setting is 1 stop bit.
Communication with slow
devices may require more than 1
stop bit.
Flow Control
None
Flow control can prevent data
loss from buffer overflow. When
sending data, if the receiving
buffers are full, a ’stop’ signal
can be sent to stop the data
flow. Once the buffers are
empty, a ‘start’ signal can be
sent to re-start the flow.
Hardware flow control uses two
wires to send start/stop signals.
VT-UTF8 Combo Key
Support
Disabled
Enabled
Enable VT-UTF8 Combination
Key Support for ANSI/VT100
terminals.
Recorder Mode
Disabled
Enabled
With this mode enabled only text
will be sent. This is to capture
Terminal data.
Resolution 100x31
Disabled
Enabled
Enables or disables extended
terminal resolution.
Legacy OS Redirection
80x24
80x25
On Legacy OS, the Number of
Rows and Columns supported
redirection.
Putty KeyPad
VT100
LINUX
XTERMR6
SCO
ESCN
VT400
Select FunctionKey and KeyPad
on Putty.
Redirection After BIOS
POST
Always Enable
BootLoader
When Bootloader is selected,
then Legacy console redirection
is disabled before booting to
Legacy OS. When Always
Enable is selected, then Legacy
console Redirection is enabled
for Legacy OS. Default setting
for this option is set to Always
Enable.