HPE Cloudline CL3100 Gen10

Software and configuration utilities 176
BIOS boot up log
The BIOS support bios boot up detection and log.
BIOS Boot Up Log
Sensor Name
BIOS Boot Up
Generic SEL
Info
Value
Description
Record Type
0x02
System Event Record
Generator ID
0x0001
Generated by BIOS
Sensor Type
0x1D
OEM
Sensor Number
0xA5
BMC define
E/R Type
0x6F
[7] Assertion [6:0] Event Trigger
Event Data1
0x00
Cold Boot, initialized by Power Up
0x02
Warm Boot, initialized by Warm Reset
Event Data2
0xFF
Event Data3
0xFF
BIOS end of POST log
The BIOS support BIOS end of post detection and log.
BIOS End Of Post Log
Sensor Name
BIOS End of Post
Generic SEL
Info
Value
Description
Record Type
0x02
System Event Record
Generator ID
0x0001
Generated by BIOS
Sensor Type
0x1D
OEM
Sensor Number
0xD2
BMC define
E/R Type
0x6F
[7] Assertion [6:0] Event Trigger
Event Data1
0x01
State Assert
Event Data2
0xFF
Event Data3
0xFF
Logging format conventions
The SMBIOS logs BIOS implemented comply with the System Management BIOS (SMBIOS) Reference
Specification Version: 3.0.0.
The SEL logs BIOS implemented comply with the logging format defined in the IPMI specification. IPMI
requires the use of all but two bytes in each event log entry, called Event Data 2 and Event Data 3. An
event generator can specify that these bytes contain OEM-specified values. The system BIOS uses
these two bytes to record additional information about the error. The below table show details:
Byte
Field
Description
1 : 2
Record ID
ID used for SEL Record access.
3
Record Type
Event description area: Record Type.
4 : 7
Timestamp
Time when event was logged. LS byte first.