HPE FlexNetwork MSR Series Command Reference

42
Field Description
• Not supported.
STBC Rx Capability
Client STBC receive capability;
• Not Supported.
• Supported.
STBC Tx Capability
Client STBC transmission capability:
• Not Supported.
• Supported.
LDPC Rx capability
Client LDPC receive capability;
• Not Supported.
• Supported.
SU beamformee capability
Client SU beamformee capability:
• Not Supported.
• Supported.
MU beamformee capability
Client MU beamformee capability:
• Not Supported.
• Supported.
Beamformee STS capability
Client beamformee STS capability:
• Not Supported.
• Supported.
Block Ack
Negotiation result of Block ACK with TID:
• IN—Sends Block ACK for inbound traffic.
• OUT—Sends Block ACK for outbound traffic.
• BOTH—Sends Block ACK for both inbound and outbound traffic.
Supported VHT-MCS set VHT-MCS supported by the client.
Supported HT MCS set HT-MCS supported by the client.
QoS mode
QoS mode:
• N/A—WMM is not supported.
• WMM—WMM is supported.
WMM information negotiation is carried out between an AP and a client that
both support WMM.
Listen interval
Interval at which the client wakes up to listen for beacon frames. It is counted
by beacon interval.
RSSI
Received signal strength indication. This value indicates the client signal
strength detected by the AP.
Rx/Tx rate Sending and receiving rates of data, management, and control frames.
Authentication method
Authentication method:
• Open system.
• Shared key.
Security mode
Security mode:
• RSN—Beacons and probe responses carry RSN IE.
• WPA—Beacons and probe responses carry WPA IE.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English