3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Do one of the following:
a. Remove the air baffle.
b. Remove the midplane drive cage .
9. Disconnect the boot device signal and power cables from the system board .
10. Remove the boot device from the top of the power supply cage:
a. Loosen the bracket thumbscrew (callout 1).
b. Remove the boot device from the chassis side wall (callout 2).
To Next Page
Loading...
