HPE ProLiant Gen10

Setting Description
Alternate Inconsistency
Repair Policy
(Does not apply to HPE Smart Array
S100i SR Gen10 SW RAID.) Controls
the behavior of the controller
inconsistency repair Policy. This
option is used to tune the controller
performance for Video applications
and requires the installation of a valid
license key. Options are Enable or
Disable.
Degraded Mode Performance
Optimization
Used to tune controller performance
for video applications and requires
the installation of a valid license key.
Options are Enabled or Disabled.
HDD Flexible Latency
Optimization
Reduces the maximum observed
latency from a host request.
Maximum drive Request
Queue Depth
Controls the maximum number of
physical drive requests that the
firmware will submit to a drive at any
given time. This option is used to
tune controller performance for video
applications. Options are 2, 4, 8, 16,
32, or Automatic.
Monitor and Performance
Analysis Delay
Controls the behavior of the controller
Monitor and Performance Analysis
Delay and is expressed in values
ranging from 0 to 60. This option is
primarily used to tune controller
performance for video applications
and requires the installation of a valid
license key.
Physical Drive Request
Elevator Sort
Controls the behavior of the controller
cache write Elevator sort algorithm.
This option is used to tune controller
performance for video applications
and requires the installation of a valid
license key. Options are Enabled or
Disabled.
RAID 6/60 Alternate
Inconsistency Repair Policy
Sets the Inconsistency Repair Policy
for the controller. Options are
Enabled and Disabled.
3. Click Submit changes.
Clearing the controller configuration
Clearing the controller configuration destroys the controller metadata, including array configurations and
partition information.
28 System Utilities main menu options