Table 6-4 Management System
Parameter Description
Server Set this parameter to the IP address or domain name of
the Management System.
Port Set this parameter based on the connected Management
System.
Address mode The value can be Comm. Address or Logical address.
If the communications address of the device connected to
the SmartLogger is unique, you are advised to select
Comm. Address. In other cases, you must select Logical
address.
TLS encryption Retain the default value Enable.
NOTE
If this parameter is set to Disable, data exchange between the
SmartLogger and the management system will not be encrypted,
which poses security risks.
TLS Version Set this parameter based on the connected Management
System. TLS1.2 or a later version is recommended.
Second challenge
authentication
Set this parameter based on the connected management
system.
NOTE
If this parameter is set to Disable, the second challenge
authentication result is not checked, and user data may be stolen.
Therefore, exercise caution when setting this parameter.
Security certicate Optional. Set this parameter only when the certicate has
expired or the customer needs to use their own certicate.
Figure 6-35 Setting management system-1 parameters
Table 6-5 Management System-1
Parameter
Description
Server Set this parameter to the IP address or domain name of
Management System-1.
SmartLogger3000
User Manual 6 WebUI Operations
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. 105
To Next Page
Loading...
Need help?
General
