Huawei SmartLogger3000 User Manual

Figure 6-72 Reactive power control
----End
No Output
Parameter Description
Reactive power control
mode
If the PV plant is not required to adjust the voltage at
the grid-connection point or perform reactive power
compensation, device can run with pure active power
output. In this case, set this parameter to No output.
DI Reactive Scheduling
NO TICE
● When setting this function, ensure that the user-dened DI port is not
occupied. Otherwise, the setting will fail.
● SmartLogger scenario: Before setting this function, ensure that the
SmartLogger is properly connected to the Ripple Control Receiver.
● SmartLogger+SmartModule scenario: Before setting this function, ensure that
the SmartModule is properly connected to the Ripple Control Receiver.
Table 6-7 SmartLogger scenario
Parameter
Description
Reactive power control
mode
Set this parameter to DI reactive scheduling.
SmartLogger3000
User Manual 6 WebUI Operations
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. 209

Huawei SmartLogger3000 Specifications

General

Brand	Huawei
Model	SmartLogger3000
Category	Data Loggers
Language	English