Updated 6.1.1 WebUI Layout.
Updated 6.1.3 WebUI Menus.
Added 6.3.3 Setting Parameters for Connecting to the Management System.
Updated 6.3.9 Setting PCS Parameters.
Updated 6.3.10 Setting CMU Parameters.
Updated 6.3.11 Setting ESU Parameters.
Updated 6.3.14 Setting HVAC Parameters.
Updated 6.4 Setting Battery Control Parameters.
Added 6.5 Setting Capacity Limit.
Updated 6.6 Setting EMS Control Parameters.
Updated 6.7.2 Setting Active Power Control.
Updated 6.7.3 Setting Reactive Power Control.
Updated 6.7.5 Setting Export Limitation Parameters.
Updated 7.4.1 Upgrading the Device Firmware Version.
Updated 7.4.3 Sending a System Maintenance Command.
Updated 7.4.4 Exporting Device Logs.
Added 7.4.8 Managing Users.
Updated 7.4.9 Collecting Performance Data.
Updated 7.4.10 Adjusting the Total Energy Yield.
Updated 8.13 Which Models of Power Meters and EMIs Are Supported by the
SmartLogger?.
Issue 08 (2021-10-15)
Updated 2.1.2 Networking.
Updated 2.2.2 Networking.
Updated 6.1.1 WebUI Layout.
Updated 6.1.3 WebUI Menus.
Updated 6.2 Device Commissioning.
Updated 6.2.1 Preparations and WebUI Login.
Added 6.2.3 Commissioning Using Deployment Wizard (V800R021C10).
Updated 6.3.1 Setting User Parameters.
Updated 6.3.2 Setting Parameters for Connecting to the Management System
(V300R001C00).
Added 6.3.9 Setting PCS Parameters.
SmartLogger3000
User Manual About This Document
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. iv
To Next Page
Loading...
Need help?
General
