Added 6.3.10 Setting CMU Parameters.
Added 6.3.11 Setting ESU Parameters.
Added 6.3.12 Setting ESC Parameters.
Added 6.3.13 Setting ESR Parameters.
Added 6.3.14 Setting HVAC Parameters.
Added 6.4 Setting Battery Control Parameters.
Updated 6.7.2 Setting Active Power Control.
Updated 6.7.5 Setting Export Limitation Parameters.
Updated 7.2 Troubleshooting.
Updated 7.3 Alarm List.
Updated 7.4.1 Upgrading the Device Firmware Version.
Updated 7.4.4 Exporting Device Logs.
Updated C Port No. List.
Updated E Acronyms and Abbreviations.
Issue 07 (2021-06-30)
Updated 6.1 Introduction to WebUI.
Updated 6.1.3 WebUI Menus.
Updated 6.3.8.1 Running Parameters.
Added 6.3.8.4 Battery.
Added 6.6 Setting EMS Control Parameters.
Updated 6.7.2 Setting Active Power Control.
Updated 7.4.4 Exporting Device Logs.
Updated 7.4.5 Starting an Onsite Test.
Updated 8.13 Which Models of Power Meters and EMIs Are Supported by the
SmartLogger?.
Issue 06 (2021-03-20)
Updated 6.3.2 Setting Parameters for Connecting to the Management System
(V300R001C00).
Updated 6.3.8.1 Running Parameters.6.3.8.1 Running Parameters
Updated 6.3.8.2 Tracking System.
Updated 6.3.16.1 Setting DL/T645 Power Meter Parameters.
Updated 6.3.16.2 Setting Modbus-RTU Power Meter Parameters.
Updated 6.3.17.1 Setting Modbus-RTU EMI Parameters.
SmartLogger3000
User Manual About This Document
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. v
To Next Page
Loading...
Need help?
General
