Hypertherm Powermax30 AIR - Replacing Power Cord and Strain Relief; Removing Power Cord and Strain Relief; CSA Power Cord Procedures

Powermax30 AIR Service Manual 808850 107
6 – Power Supply Component Replacement
Replace the power cord and strain relief
Remove the power cord and strain relief
CSA power cords
1. Complete the following procedures:
a. Set the power switch to OFF (O), and disconnect the power cord from the power source.
b. See Remove the power supply cover on page 98.
c. See Remove the component barrier on page 100.
d. See Detach the rear panel on page 104.
Kit number Description
228210 Kit: CSA power cord with NEMA twist lock-style 240 V / 20 A plug, 1-phase, 3.0 m
(10 feet) (strain relief not included)
428390 Kit: CE power cord, 1-phase, 3.0 m (10 feet) (plug and strain relief not included)
228143 Kit: Power cord strain relief