Hypertherm Powermax30 AIR - Cutting Specifications

Powermax30 AIR Service Manual 808850 21
1 – Specifications
Cutting specifications
240 V
Recommended cut capacity* 8 mm (5/16 inch) at a minimum of 500 mm/minute (20 inches/minute)
10 mm (3/8 inch) at a minimum of 250 mm/minute (10 inches/minute)
Severance cut capacity 16 mm (5/8 inch) at a minimum of 125 mm/minute (5 inches/minute)
* When you operate this system at altitudes higher than 2,200 m (7,500 feet) above sea level, you may experience some reduction
in cutting performance due to the adverse effect that altitude has on air compressors.
120 V: When you operate the system at the maximum recommended output of 20 A, the cut capacities are:
 3mm (10gauge) at 762mm/minute (30inches/minute)
 6 mm (1/4 inch) at 355 mm/minute (14 inches/minute)
 10 mm (3/8 inch) at 125 mm/minute (5 inches/minute)