1.3 Options
1-95
1. Specifications
1.3 Options
With brake (model: B)
This is used to prevent the slider or rod from moving during power outages or when the servo is
OFF.
It can also be used to prevent the slider or rod from falling when mounted vertically.
Tip adapter (flange) (model: FFA)
This adapter is used to mount jigs, etc., on the rod tip with four bolts.
* Refer to Body Mounting (page 2-45/62) for details.
Flange (model: FL)
This bracket is used for fixing the actuator body side with bolts.
* Refer to Body Mounting (pages 2- 26/40/57) for details.
Foot bracket (model: FT)
This bracket is used for fixing the actuator body from the top with bolts.
* Refer to Body Mounting (pages 2-10/23/38) for details.
Tip adapter (Internal thread) (model: NFA)
This adapter is used to secure jigs, etc., on the rod tip with one bolt for rod types.
* Refer to Body Mounting (page 2-32/44/61) for details.
Knuckle joint (model: NJ)
When using a clevis bracket, this bracket is used to allow the actuator rod tip to move freely
(rotate).
* Refer to Body Mounting (page 2-48/65) for details.
Oscillation receiving bracket (knuckle joint) (model: NJPB)
This is the oscillation receiving bracket for the knuckle joint.
* Refer to Body Mounting (page 2-50/68) for details.