What does CA5 error mean on IAI X-SEL?
The CA5 error on the IAI Controller indicates a mechanical issue or a faulty power stage board. First, check if the actuator mounting bolts are contacting inside the axes or if the slider attachment is contacting any surrounding mechanical parts. If the mechanical function is fine, the power stage board is likely faulty and needs replacement.
What to do if IAI Controller shows ErG error?
The ErG error on the IAI Controller indicates that an emergency-stop signal is being input. This can occur if: the emergency-stop button on the teaching pendant is pressed; the applicable input terminal in the system connector is turned ON; the port switch on the front panel is set to the manual side without the teaching-pendant/PC-software connector connected; or, if the actuator is of sensor specification and the slider is stopped on either end of the slider. To resolve this, review these conditions and take the necessary corrective actions.
What to do if IAI X-SEL displays error 914 CA2?
If your IAI Controller displays error code 914 CA2, it could be due to several reasons: the PG cable might be disconnected, an absolute reset hasn't been performed after the initial setup, or the voltage of the absolute-data backup battery is low. To resolve this, connect the PG cable to the controller and perform an absolute reset. If the problem persists, replace the absolute-data backup battery and then execute another absolute reset.
What causes C6b error on IAI X-SEL Controller?
The C6b error on your IAI Controller indicates that the operation is mechanically disabled. Check to see if the actuator mounting bolts are contacting inside the axes, or if the slider attachment is contacting any surrounding mechanical parts.
What does d19 error mean on IAI X-SEL?
The d19 error on your IAI Controller indicates that the encoder cable is disconnected. To resolve this, replace the encoder cable.
How to resolve d06 error on IAI X-SEL Controller?
The d06 error on your IAI Controller indicates that the encoder cable is disconnected. To fix this, replace the encoder cable.
What to do if IAI Controller shows oPG error?
If your IAI Controller displays the 'oPG' error, it means the safety gate is open. To resolve this, check the system connector wiring.
What to do if IAI X-SEL displays error C9C?
If your IAI Controller displays error C9C, it indicates that the phase-Z position is defective or the reversing amount at home return is small. Check if any foreign objects have entered the actuator and ensure the mounting bolts are not contacting the slider. Additionally, change axis-specific parameter No. 22 to “100.”
What causes d18 error on IAI Controller?
The d18 error on an IAI Controller indicates that the driver CPU board was damaged due to noise in the encoder cable. To resolve this, replace the board and implement noise control measures.
How to fix d03 error on IAI Controller?
The d03 error on your IAI Controller suggests that the encoder is faulty or has dust attached. Remove the motor cover and use cleaning air spray designed for OA equipment on the cord wheel. If the problem continues, you may need to replace or readjust the encoder.
General| Brand | IAI |
|---|---|
| Model | X-SEL |
| Category | Controller |
| Language | English |
To Next Page
