What to do if IAI X-SEL displays CA5 error?
If your IAI Controller displays the CA5 error, it indicates that the operation is mechanically disabled or the power stage board is faulty. First, check if the actuator mounting bolts are contacting inside the axes or if the slider attachment is contacting any surrounding mechanical parts. If there are no mechanical issues, replace the power stage board.
What to do if IAI X-SEL Controller displays error d10?
If your IAI Controller displays error d10, it may be due to a damaged motor coil or a faulty power stage board. First, measure the relative resistance among phases U/V/W. If the resistance values differ, the coil is likely burned, and you should replace the motor. However, if the resistance values are nearly identical, the coil is likely fine, and you should replace the power stage board (where the motor power cable connects).
Why does my IAI Controller show ACF error?
The ACF error on your IAI Controller typically indicates a momentary power failure or a voltage drop. This can also occur if you are inputting 100V into a controller that requires 200V. To fix this, check the power source voltage. Note that if the last digit of your controller's model number is '-1,' it requires 100V, while '-2' indicates a 200V specification.
General| Brand | IAI |
|---|---|
| Model | X-SEL |
| Category | Controller |
| Language | English |
To Next Page
