Chapter 8. Advanced host and volume administration 435
Figure 8-79 Volumes by Host option
2. The Volumes by Host panel opens, as shown in Figure 8-80.
Figure 8-80 Volumes by Host panel
3. The host filter is in the left pane of the view. Selecting a host shows its properties in the
right pane, such as the host name, number of ports, host type, and the I/O group to which
it has access.
The right pane, next to the host name, shows icons for Fibre Channel, iSCSI and SAS
connectivity. Depending on the type of host connectivity, the respective icon will be
highlighted and the other icons will be disabled.
The volumes that are mapped to this host are listed in the table in the lower-right part of
the panel.
4. You can create a volume from this panel. Click Create Volumes to open the same wizard
as described in Chapter 6, “Volume configuration” on page 287.
Selecting a volume and opening the Actions menu or right-clicking the volume shows the
same options, as described in 8.3, “Advanced volume administration” on page 405.
To Next Page
Loading...
Need help?
General