To Next Page

To Previous Page

366 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1

Configuring hosts

Follow this step of the wizard to select or configure new hosts as required. Figure 7-18 shows

the Configure Hosts (optional) panel. If hosts are defined, they are listed in the panel as

shown in Figure 7-20 on page 368.

1. If no hosts are defined, they can be created by selecting the Add Host option.

Figure 7-18 Configure Hosts panel

MDisk selection: Select only the MDisks that are applicable to the current migration plan.

After the current migration completes, you can start another migration to migrate any

remaining MDisks.

Note: This step is optional. You can bypass it by selecting Next and moving to “Mapping

volumes to hosts” on page 368.

Other manuals for IBM Storwize V5030

Questions and Answers:

Need help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

General