To Next Page

To Previous Page

76 Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1

After you are logged in, you see the Service Assistant Tool Home window, as shown in

Figure 2-49.

Figure 2-49 Service Assistant Tool Home window

The current canister node is displayed in the upper-left corner of the GUI. As shown in

Figure 2-49, the current canister node is node 1. To change the canister, select the relevant

node in the Change Node section of the window. You see that the details in the upper-left

corner change to reflect the new canister.

The SA GUI provides access to service procedures and shows the status of the node

canisters. We advise that you perform these procedures only if you are directed to use them

by IBM Support.

For more information about how to use the SA Tool, see the following website:

https://ibm.biz/BdjSJq

Other manuals for IBM Storwize V5030

Questions and Answers:

Need help?

Do you have a question about the IBM Storwize V5030 and is the answer not in the manual?

General