IBM TS7650 - Page 114

b. Attach a graphics-capable monitor to the video port on the back of the
server.
Note: If you are unable to connect to the server by using the procedure in step
1 on page 87, see Appendix C, “Making a server connection through the IMM,”
on page 151 for instructions on connecting to the server by using the IMM in
the server and your service notebook or the TSSC.
2. At the command line, log in with the ID root and the password admin.
Note: During the boot cycle, the ProtecTIER file systems are mounted. If the
message: Running... displays, press Enter to proceed to the login prompt.
3. Enable RAS on the server:
a. At the command line, type menu and press Enter. The ProtecTIER Service
menu displays.
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasap1
----------------------------------------------------------------------
1) ProtecTIER Configuration (...)
2) Manage ProtecTIER services (...)
3) Health Monitoring (...)
4) Problem Alerting (...)
5) Version Information (...)
6) Generate a service report
7) Generate a system view
8) Update ProtecTIER code
E) Exit
----------------------------------------------------------------------
>>> Your choice?
b. Type the numeral corresponding to ProtecTIER Configuration and press
Enter. The ProtecTIER Configuration menu displays.
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasap1
ProtecTIER Configuration (...)
----------------------------------------------------------------------
1) Configure ProtecTIER node
2) Recover Configuration for a replaced server
3) Configure RAS
4) Update Time, Date, Timezone & Timeserver(s)
5) Configure replication (...)
6) IP Network configuration (...)
7) Update Firmware
8) Update the System’s name
9) Validate configuration
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
c. Type the numeral corresponding to Configure RAS and press Enter.
d. Follow the on-screen instructions to complete the configuration process.
Important:
v If you receive an error that the frame range number entered is already in
use, specify a different range in an increment of 10. For example, if frame
range 20 is already in use, try frame range 30.
v For clustered configurations, use the same frame (location) number for
both nodes when clustered together in the same frame.
88 IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide