IBM TS7650 - Using a Screen Reader to Install Protectier Manager

c. Go on to step 8.
8. On the ProtecTIER Manager workstation, double-click the
accessbridge-x.x.x.exe installer file.
A security warning dialog box displays.
9. Click Run.
The Java Access Bridge – InstallShield Wizard opens.
10. Read the welcome information, then click Next and follow the on-screen
instructions to complete the installation.
11. When the installation is complete, restart the workstation as directed.
You now have the necessary Java tools for compatibility between the
ProtecTIER Manager installation wizard and screen reader software.
12. Follow the instructions in “Using a screen reader to install ProtecTIER
Manager” to start the ProtecTIER Manager installation wizard by using a
screen reader.
Using a screen reader to install ProtecTIER Manager
About this task
Install ProtecTIER Manager according to the following command line-based
instructions.
i
When entering the commands, type them exactly as shown, including any
spaces or quotation marks. Any deviation in the procedure can cause the
installation to start in the non-accessible mode, or fail completely.
Procedure
1. If your workstation is configured to automatically open DVDs, temporarily
disable the Windows AutoPlay feature for the CD/DVD device. Use the
Windows Help or other Windows documentation for instructions, and then go
on to step 2.
2. Insert the IBM System Storage ProtecTIER Manager V3.1.8 DVD into the
CD/DVD drive of the ProtecTIER Manager workstation.
3. Access the command prompt on the ProtecTIER Manager workstation:
a. Click Start > Run....
The Run dialog box opens.
4. In the Open field, type: cmd and click Ok.
The command window opens.
5. Browse to the ProtecTIER Manager installation directory on the DVD. To do so:
a. At the command prompt, type: D: (where D: is the letter assigned to the
CD/DVD drive of the workstation) and press <enter>.
b. At the command prompt, list the contents of the DVD. Type: dir and press
<enter>.
c. Locate the name of the ProtecTIER Manager directory on the DVD. For
example: PT_Manager_V3.1.5.0.
d. At the command prompt, change to the ProtecTIER Manager directory.
Type: cd <directory name> and press <enter>. For example:
cd PT_Manager_V3.1.5.0 <enter>.
e. At the command prompt, change to the Windows directory. Type:
cd windows and press <enter>.
172 IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide