And press Enter. You are prompted to enter information for the second
destination server and the local network.
v Second destination server, VTL configuration target: enter eth5
v Second destination server, OpenStorage configuration target: enter eth11
h. At each prompt, type the requested information and then press Enter:
Please provide the following information:
Target Network Address: (for example: 10.11.196.0) (starting network
address)
Target Network Netmask: (for example: 255.255.255.0)
Local Gateway Address: (for example: 10.11.197.0) (the gateway IP address of
the server you are currently configuring)
An updated summary displays:
ID Target
Network Address
Target Netmask Local Gateway
Address
1 10.11.194.0 255.255.255.0 10.11.195.1
2 10.11.196.0 255.255.255.0 10.11.197.1
Attention: The addresses in the summary are examples. In this instance,
the term target refers to the network address of the nodes at site 1 and site
2. Actual values vary. Depending on your replication configuration, if more
than one node is replicating to a single node, the remote node Target
Network Address might be the same network starting address for Server A
and B. For reference, write the actual values from the summary screen in
the blank spaces in the VTL or OpenStorage worksheets, as applicable. If
you are configuring:
v VTL, use worksheets Table 34, Table 35 on page 111, Table 36 on page 111,
and Table 37 on page 111.
v OpenStorage with Feature Code 3456, use worksheets Table 38 on page
111, Table 39 on page 112, Table 40 on page 112, and Table 41 on page 112.
v OpenStorage with Feature Code 3457, use worksheets Table 42 on page
112, Table 43 on page 113, Table 44 on page 113, and Table 45 on page 113.
Table 34. Site 1 – Server A VTL worksheet
Site 1 – Server A
ID Target
Network Address
(Remote nodes
starting network
address)
Target Netmask
(Remote nodes
netmask)
Local Gateway
Address
(The gateway address
for Server A at Site 1)
1 (eth2)
2 (eth5)
110 IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide