v In a new Program Group – This option creates a new program group in the
Program list of the Start menu.
v In an existing Program Group – This option adds the shortcut to an
existing program group in the Program list of the Start menu.
v In the Start Menu
v On the Desktop
v In the Quick Launch Bar
v Other – Enables you to enter a path location for the shortcut, or to browse
for a location by clicking Choose.
v Dont create icons – No shortcuts are created.
Note: When relevant, you can select Create Icons for All Users to create a
shortcut in the defined location for all user accounts on the workstation.
6. Click Next.
7. Review the Summary screen, and then click Install to start the installation.
8. Click Done.
The ProtecTIER Manager installation wizard closes.
9. Install Storage Manager. Follow the directions as they are provided. Ensure
that the customer is aware of the restriction discussed in the following note.
Note: When using Storage Manager, do not alter the naming convention of
the storage subsystems for the Appliance or Gateway. ProtecTIER RAS code
requires the name remain at its manufactured naming convention
(DS_Cache_Subsystem or DiskArray-xxx-xxx) for proper storage error
reporting.
10. Go to “Adding a node” on page 134.
Installing on a Linux workstation
This topic describes how to install ProtecTIER Manager on a Linux workstation.
Before you begin
Important: The following procedure assumes that the workstation on which
ProtecTIER Manager is being installed has a Linux GUI. A GUI is required for
ProtecTIER Manager operation on Linux.
About this task
The ProtecTIER Manager installation wizard and the ProtecTIER Manager
application are fully compatible with the JAWS screen-reader software. ProtecTIER
Manager also allows you to change other accessibility settings, such as the contrast
resolution mode and color palette. Instructions for installing JAWS and the
Java-based accessibility tools, and for setting the contrast resolution mode and
color palette are available in “Accessibility for publications and ProtecTIER
Manager” on page 169.
Procedure
Perform the following steps to install ProtecTIER Manager on a Linux workstation.
1. Insert the IBM System Storage ProtecTIER Manager V3.1.8 DVD into the
CD-ROM drive of the designated ProtecTIER Manager workstation.
Chapter 8. Installing ProtecTIER Manager and Storage Manager 131
|
|
|
|
|
|
|
To Next Page
Loading...
