IBM TS7650 - Factory-Default Server IP Addresses for a Stand-Alone VTL Protectier Server (3958 DD4 or 3958 AP1); Factory-Default Server IP Addresses for a Stand-Alone Openstorage Protectier Server (3958 DD4 or 3958 AP1)

Attention:
1. All components use subnet mask 255.255.255.0.
2. Do not configure the replication ports on the same subnet as the external LAN
port Eth0. Doing so may cause replication errors.
Factory-default IP addresses for a stand-alone VTL configuration
for a TS7650G 3958 DD4 or TS7650 Appliance
Table 48. Factory-default server IP addresses for a stand-alone VTL ProtecTIER server (3958 DD4 or 3958 AP1)
Stand-alone TS7650 VTL
configuration Component Port Function
Factory Default IP
Address
Node A (the server located in the
lower part of the rack)
Server A eth0 Customer local
LAN
192.168.10.161
Server A eth1 Cluster network 1 N/A
Server A eth2 Replication network
1
192.168.20.1
Server A eth3 RAS 172.31.1.xx
Server A eth4 Cluster network 2 N/A
Server A eth5 Replication network
2
192.168.21.1
Factory-default IP addresses for a stand-alone OpenStorage
configuration for a TS7650G 3958 DD4 or TS7650 Appliance
Table 49. Factory-default server IP addresses for a stand-alone OpenStorage ProtecTIER server (3958 DD4 or 3958
AP1)
Stand-alone TS7650
OpenStorage configuration Component Port Function Factory Default IP Address
Node A (the server located
in the lower part of the
rack)
Server A eth0 Customer local LAN 192.168.10.161
Server A eth1 Cluster network 1 N/A
Server A eth2 Free N/A
Server A eth3 RAS 172.31.1.xx
Server A eth4 OpenStorage 192.168.150.1
Server A eth5 OpenStorage 192.168.151.1
Server A eth6 OpenStorage 192.168.152.1
Server A eth7 Replication 1 192.168.20.1
Server A eth8 OpenStorage 192.168.153.1
Server A eth9 OpenStorage 192.168.154.1
Server A eth10 OpenStorage 192.168.155.1
Server A eth11 Replication network 2 192.168.21.1
Server A eth12 Cluster network 2 N/A
Server A eth13 Free N/A
144 IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide
||||
||||