Factory-default server IP addresses for a clustered OpenStorage
TS7650G 3958 DD4 or TS7650 Appliance
Table 51. Factory-default server IP addresses for a clustered OpenStorage ProtecTIER system (3958 DD4 or 3958
AP1)
TS7650 clustered VTL
system Component Port Function
Factory Default IP
Address
Node A (the server located in
the lower part of the rack)
Server A eth0 Customer local LAN 192.168.10.161
Note: By default, the TS7650 servers use the IP address range 10.0.0.50 through
10.0.0.59 for the power control network. The server IP addresses do not change from
frame to frame.
Server A eth1 Cluster network 1 10.0.0.51
Server A eth2 Free
Server A eth3 RAS 172.31.1.xx
Server A eth4 OpenStorage 192.168.150.1
Server A eth5 OpenStorage 192.168.151.1
Server A eth6 OpenStorage 192.168.152.1
Server A eth7 Replication network 1 192.168.20.1
Server A eth8 OpenStorage 192.168.153.1
Server A eth9 OpenStorage 192.168.154.1
Server A eth10 OpenStorage 192.168.155.1
Server A eth11 Replication network 2 192.168.21.1
Server A eth12 Cluster network 2 10.0.0.51
Server A eth13 Free
Network Power Switch N/A 10.0.0.50
Node B (the server located in
the upper part of the rack)
Server B eth0 Customer local LAN 192.168.10.162
Note: By default, the TS7650 servers use the IP address range 10.0.0.50 through
10.0.0.59, for the power control network. The server IP addresses do not change from
frame to frame.
Server B eth1 Cluster network 1 10.0.0.52
Server B eth2 Free
Server B eth3 RAS 172.31.1.xx
Server B eth4 OpenStorage 192.168.150.2
Server B eth5 OpenStorage 192.168.151.2
Server B eth6 OpenStorage 192.168.152.2
Server B eth7 Replication network 1 192.168.20.2
Server B eth8 OpenStorage 192.168.153.2
Server B eth9 OpenStorage 192.168.154.2
Server B eth10 OpenStorage 192.168.155.2
Server B eth11 Replication network 2 192.168.21.2
Server B eth12 Cluster network 2 10.0.0.52
Server B eth13 Free
Network Power Switch N/A 10.0.0.50
146 IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide
To Next Page
Loading...
