Appendix B. IP address worksheet
Use this worksheet to specify the IP addresses assigned to the TS7650G or TS7650
Appliance components. IBM service representatives use the information provided
to define the IP addresses of components supported by the TSSC. When the TSSC
sends Call Home information to IBM through VPN or modem, or sends you
notices about serviceable events, these settings will be included in the information
to identify and provide important information about the TSSC that sent a service
request.
Table 48 on page 144 and Table 50 on page 145 show the default IP addresses for
the TS7650G and TS7650 Appliance servers with VTL configurations.
Table 49 on page 144 and Table 51 on page 146 show the default IP addresses for
the TS7650G and TS7650 Appliance servers with OpenStorage configurations.
Table 53 on page 147 shows the IP address, network mask, DNS and VLAN
settings for the source and destination servers for replication. This information is
needed to configure the individual ports to communicate and transfer data over
the replication network. Write this information in the spaces provided for future
reference. Table 54 on page 148 shows the host names and other settings needed
for replication. Write the appropriate information in the spaces provided for future
reference.
Table 55 on page 149 shows the default IP addresses for the TSSC.
Table 56 on page 150 shows the IP address ranges for the gateway or appliance
components once they are configured to be on the TSSC's 172.31.1.xx network. In
the spaces provided in Table 56 on page 150, write the IP addresses that you assign
for each component, so that the IP address information is available for future
reference.
© Copyright IBM Corp. 2011 143
To Next Page
Loading...
