EasyManuals Logo
Home>IBM>Storage>TS7650

IBM TS7650 User Manual

IBM TS7650
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
Power
®
connections
The tasks in this section describe the power connections for the components in a
TS7650 Appliance stand-alone configuration.
About this task
1. Use Table 10 and Figure 14 on page 30 to verify the power connections made in
manufacturing.
Important:
v The same label set is used to cable both the Appliance and the Gateway.
While server labels display the model as DD4 (the server model for the
gateway), and DD4 appears in this document in some tables and graphics,
interpret this label as AP1 for Appliance installations.
v All power connections from the TS7650 components to the PDUs were
completed in manufacturing.
v TSSC power cable TJ5 might not be present in the ship group. If not, connect
the TSSC to the PDU by using only power cable BJ5.
v SC P2 labels (6) are used only with TSSCs that use a second power cable.
Single power cable to Server DD4A 8 not used currently.
v In the following diagrams, the letters TJ followed by a number (for example:
TJ5) indicate which outlet the associated component plugs into on the To p
PDU. The letters BJ followed by a number (for example: BJ8) indicate which
outlet the associated component plugs into on the Bottom PDU.
2. Make any necessary adjustments to cable placement or labeling, then go to
“KVM switch, TSSC, and customer network connections” on page 31.
Table 10. Power cables for stand-alone and clustered configurations
Label From To Remarks
1 Bottom PDU J10 Lower Ethernet switch Not used for stand-alone
installation
2 Top PDU J10 Upper Ethernet switch Not used for stand-alone
installation
3 Bottom PDU J4 System console (TSSC)
Ethernet switch
4 Top PDU J4 TSSC KVM assembly
5 Bottom PDU J5 System console, plug 1
6 Top PDU J5 System console, plug 2 Use dependent on
customer order
7 Bottom PDU J3 KVM Switch
8 Top PDU J8 DD4A P1 May be used in place of
10 in stand-alone
installations in which
the server is
customer-installed in the
frame.
9 Bottom PDU J8 DD4A P2 May be used in place of
12 in stand-alone
installations in which
the server is
customer-installed in the
frame.
28 IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM TS7650 and is the answer not in the manual?

IBM TS7650 Specifications

General IconGeneral
BrandIBM
ModelTS7650
CategoryStorage
LanguageEnglish

Related product manuals