KVM switch, TSSC, and customer network connections
This topic describes the correct Ethernet cabling for the KVM switch, TSSC, and
customer network in a stand-alone appliance.
About this task
Important: All cable connections were completed in manufacturing.
Notes:
1. Your installation shipped with one of two models of the TSSC. While the port
designations are identical for the two models, the physical port layout differs
between them. Figure 15 shows the port layout for one model and Figure 16 on
page 32 shows the port layout for the other; use the appropriate figure for your
installation as a reference.
2. Figure 15 and Figure 16 on page 32 show a VTL configuration. For KVM
switch, TSSC, and customer network connections (other than replication and
OpenStorage customer host network connections), the connections for an
OpenStorage configuration are identical. For replication connections for VTL
and OpenStorage configurations and for OpenStorage customer host network
connections, see “Replication and OpenStorage customer host network (Feature
Code 3456) connections” on page 33 and “Fibre Channel connections in a
stand-alone OpenStorage configuration” on page 41.
KVM
switch
1
2
3
4
5
6
7
8
Terminator
P
SC SW
SC Server
SC KVM
1
2
3 4
1
2
3
4
5
6
7
8
9
10
13
12
11
14
15
16
U1
1
2
1
2
1
2
1
2
ProtecTIER Server A
1
2
3 4 5 6 7
1
2
3
4
PP
8
9
A1 A2 B V S
E1
E2
E3
E4
V
U3 U4
23
22
21
24
9
11
10
Customer
Network
ts760914
13
Figure 15. KVM switch, TSSC, and customer network Ethernet cabling (VTL and
OpenStorage configurations, TSSC variant 1)
Chapter 3. Installing the appliance 31
|
|
|
|
|
|
|
|
|
To Next Page
Loading...
Need help?
General