IBM TS7650 - Page 132

a. At the command line, type menu and then press Enter. The ProtecTIER
Service menu displays.
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasap1
----------------------------------------------------------------------
1) ProtecTIER Configuration (...)
2) Manage ProtecTIER services (...)
3) Health Monitoring (...)
4) Problem Alerting (...)
5) Version Information (...)
6) Generate a service report
7) Generate a system view
8) Update ProtecTIER code
E) Exit
----------------------------------------------------------------------
>>> Your choice?
b. Type the numeral corresponding to ProtecTIER Configuration and press
Enter. The ProtecTIER Configuration menu displays.
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasap1
ProtecTIER Configuration (...)
----------------------------------------------------------------------
1) Configure ProtecTIER node
2) Recover Configuration for a replaced server
3) Configure RAS
4) Update Time, Date, Timezone & Timeserver(s)
5) Configure replication (...)
6) IP Network configuration (...)
7) Update Firmware
8) Update the System’s name
9) Validate configuration
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
c. Type the numeral corresponding to Configure replication and press Enter.
The Configure Replication menu displays.
----------------------------------------------------------------------
ProtecTIER Service Menu running on rasap1
ProtecTIER Configuration (...)
Configure Replication (...)
----------------------------------------------------------------------
1) Replication IP addresses
2) Activate/Deactivate ProtecTIER Replication Manager on this node
3) Configure Static Routes
B) Back
E) Exit
----------------------------------------------------------------------
>>> Your choice?
d. Type the numeral corresponding to Replication IP addresses and press
Enter.
e. Enter the new IP address for eth2 and eth5 (for VTL configuration) or eth7
and eth11 (for OpenStorage configuration).
3. Change the ProtecTIER system name from the one assigned during
manufacturing to one specific to the environment at the customer site:
a. At the command line, type menu and then press Enter. The ProtecTIER
Service menu displays.
106 IBM System Storage TS7650 ProtecTIER Deduplication Appliance: Installation Roadmap Guide