Icom IC-7700 - Page 184

12-22
12
SET MODE
Network AF Sample Rates 8kHz, 12kHz, 16kHz
Selects the limitation of the received audio sampling
rate that Remote stations can adjust.
8 kHz, 12 kHz, 16 kHz, 24 kHz and 48 kHz are se-
lectable. (default: 16 kHz)
Higher sampling rates will improve the audio qual-
ity. However, they also increase the amount of data,
which can cause voice delay or jumpiness, depend-
ing on the network condition.
Lower sampling rates will decrease the audio quality.
However, they also decrease the amount of data.
Codecs LPCM 8bit, u-law 8bit, LPCM 16bit
Sets the received audio codecs that Remote stations
can adjust.
LPCM 8 bit, u-law 8 bit and LPCM 16 bit are selecta-
ble. (default: LPCM 8bit, u-law 8bit, LPCM 16bit)
Network MOD Use ON
Selects whether or not to allow Remote stations to
send the modulation audio. (default : ON)
•ON: The Remote stations send the modulation
audio.
•OFF:TheRemotestationsdonotsendthemodula-
tion audio.
Sample Rates 8kHz
Selects the limitation of the modulation audio sam-
pling rate that Remote stations can adjust.
8 kHz, 12 kHz, 16 kHz, 24 kHz and 48 kHz are se-
lectable. (default: 8 kHz)
Higher sampling rates will improve the audio quality.
However, they also increase the amount of data,
which can cause voice delay or jumpiness, depend-
ing on the network condition.
Lower sampling rates will decrease the audio quality.
However, they also decrease the amount of data.
Codecs LPCM 8bit, u-law 8bit, LPCM 16bit
Sets the transmit audio codecs that Remote stations
can select.
LPCM 8 bit, u-law 8 bit and LPCM 16 bit are selecta-
ble. (default: LPCM 8bit, u-law 8bit, LPCM 16bit)
■ Other set mode (continued)