Icom IC-7700

12-21
12
SET MODE
Network User2 ID
Register the Users ID to allow them to remotely ac-
cess the IC-7700. The IC-7700 can register three
users to Network User1 ID to Network User3 ID.
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this reg-
istration.
See the Network User1 ID on the previous page for
setting details.
•YoucannotregisterthesameIDwithUser1orUser3,if
the ID is already registered.
Password
Register the password for the Network User2 ID. See the Password of Network User1 ID on the previ-
ous page for setting details.
Administrator NO
Selects the administrator setting YES or NO for Net-
work User2 ID. (default: NO)
When this item is set to “YES,” the Remote station
can terminate a connection between another Remote
station and the IC-7700.
Network User3 ID
Register the Users ID to allow them to remotely ac-
cess the IC-7700. The IC-7700 can register three
users to Network User1 ID to Network User3 ID.
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this reg-
istration.
See the Network User1 ID on the previous page for
setting details.
•YoucannotregisterthesameIDwithUser1orUser2,if
the ID is already registered.
Password
Register the password for the Network User3 ID. See the Password of Network User1 ID on the previ-
ous page for setting details.
Administrator NO
Selects the administrator setting YES or NO for Net-
work User3 ID. (default: NO)
When this item is set to “YES,” the Remote station
can terminate a connection between another Remote
station and the IC-7700.
Network Radio Name IC-7700
Enters the Network Radio name of up to 16 charac-
ters. The name displays on an RS-BA1’s Remote
Utility.
DO NOT use the duplicated name on your network.
Only when you configure the remote control sys-
tem using an optional RS-BA1, you need this reg-
istration.
z Push [EDIT]
F-5
to enter the Network Radio
Name Edit mode.
x Rotate the main dial to input a Network Radio
Name of up to 16 characters.
 •Push[ABC](MF6)or[abc](MF6)totoggleupperand
lower case letters.
 •Push[123](MF7)or[Symbol](MF7)totogglebetween
numerals and symbols.
 •Push[t]
F-1
or [u]
F-2
for cursor movement.
 •Push[DEL]
F-3
to delete the selected character.
c Push [SET]
F-5
to set.
■ Other set mode (continued)