The microphone can also be used to program mem-
ory channels.
z Set the desired frequency in the VFO mode.
± Push [VFO/LOCK] to select the VFO mode.
± Push [
ENT C(T-OFF)], then set the frequency using the
keypad.
± Set other data (e.g. frequency offset, duplex direction,
tone squelch, current call signs, etc.), if desired.
x Push [MR/CALL] to enter the memory mode.
c Push [
ENT C(T-OFF)], then set the desired memory chan-
nel using the keypad.
v Push [VFO/LOCK] to select the VFO mode.
b Push [FUNC] then push and hold [
CLR A(MW)] for 1 sec.
to program.
± 3 beeps may sound and the VFO contents
(including the
subaudible tone frequency, etc.) are programmed.
± Memory channel number increases when continuing to
push [
CLR A(MW)] after programming.
D Programming a memory channel via the microphone
Push ,
Push then for 1 sec. and continue to push
MR/
CALL
Push then Push
Push
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel).
91
7
MEMORY/CALL CHANNELS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
To Next Page
Loading...
