48
5
DV MODE OPERATION
N DR (D-STAR Repeater) mode operation
DR (D-STAR Repeater) mode is used for D-STAR repeater
operation. In this mode, you can select the pre-programmed
repeaters and UR call sign by using [DIAL].
• DR mode operation flow chart
Step 3: (RPT2 selection)
Select link repeater, gateway repeater
or if other station is in the same area,
select NOT USE.
Push PTT to transmit, release to receive.
Step 1: (RPT1 selection)
Select the access repeater.
- Access repeater scan is useful to find a repeater.
Step 2: (UR call sign selection)
Select UR call sign.
Calling a CQ
In the same area: CQCQCQ
To other area: Repeater name
In the same area: NOT USE
In the same zone: Repeater name
To a different zone: GW
Calling a specific station
• Repeater settings can be stored into a memory channel.
D Access repeater scan
q Push [DR] to select the DR mode.
• The DV mode is selected automatically.
w Push and hold [SCAN](VFO/MHz) for 1 sec. to start the
scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
• Push [SCAN](VFO/MHz) to stop the scan.
[SCAN]
During access repeater scan
To Next Page
Loading...
