Icom ID-E880 - Monitor Function Usage; Audio Mute Functionality

20
2
BASIC OPERATION
N Monitor function
This function is used to listen to weak signals without disturb-
ing the squelch setting.
[MONI]
± Push [MONI] to open the squelch.
• “BUSY” blinks.
• Push [MONI] again to cancel the function.
MONI
1
± Push [MONI 1(BANK)] to open the squelch.
• Push [MONI 1(BANK)] again to cancel the function.
NOTE: When the [SQL] adjustment is set too far clock-
wise, (13–17 o’clock position) the squelch attenuator is
activated. To monitor weak signals on the operating fre-
quency, deactivate the squelch attenuator function. See
page 19 for details.
N Audio mute function
This function temporarily mutes the audio without disturbing
the volume setting. (microphone only)
MUTE
± Push [FUNC] then [SQLY D(MUTE)] to mute
audio signals.
• Push [CLR A(MW)] (or any other key) to cancel the
function.
Shows above indications alternately