Icom ID-E880 - Clearing Repeater Lists

41
4
DV MODE PROGRAMMING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
e Rotate [DIAL] to select the desired repeater list to be
changed.
r Push [ ](MONI) to enter the list.
t Rotate [DIAL] to select the content to be changed, then
push [ ](MONI) to enter the content and reprogram the
content (see pages 35–38 for new repeater list program-
ming details).
y After programming is finished, rotate [DIAL] to select “ADD
W” or “OVR W,” then push [
](MONI) to store to a new list
or overwrite the selected list, respectively.
When “ADD W” is selected;
• “ADD W OK?” appears.
When “OVR W” is selected;
• “OVR W OK?” appears.
u Push [ ](MONI) again to store the list.
N Clearing a repeater list
Contents of programmed list can be cleared (erased) .
q Enter “EDIT-L” in RPT-L menu.
MENU ¶ RPT-L ¶ EDIT-L
(Push [MENU ]), (rotate [DIAL], then push [ ](MONI).)
• Programmed repeater name appears.
w Rotate [DIAL] to select the desired repeater list to be
erased.
• Push and hold [BAND] for 1 sec. to enter group selection, rotate
[DIAL] to select the desired group (0–9) then push [BAND].
e Push [ ](MONI) to enter the list.
r Rotate [DIAL] to select “CLEAR,” then push [ ](MONI).
• “CLEAR OK?” appears.
t Push [ ](MONI) again to clear the list.