Icom ID-E880

140
10
MENU SCREEN OPERATION
- DATA extension
Sets the data extension capability to “CUR.SPD” or OFF (de-
fault).
The transceiver’s course and speed information is addition-
ally transmitted with position data when “CUR.SPD” is se-
lected.
NOTE: When “CUR.SPD” is selected, number of character
for “COMMENT” is limited to 36.
- Time stamp
Selects transmitting time stamp type from DHM, HMS and
OFF. This function transmits UTC (Universal Time Coordi-
nated) time only.
• OFF : No time stamp is transmitted. (default)
• DHM : Time stamp in the format of Day, Hour and
Minute is transmitted.
• HMS : Time stamp in the format of Hour, Minute and
Second is transmitted.
- GPS-A symbol
Selects the desired GPS-A symbol.
Available symbols: AMBU (Ambulance), BUS (Bus), FIRE
(Fire Truck), BICYCL (Bicycle), YACHT (Yacht), HELI (He-
licopter), AIRCRA (Small Aircraft), SHIP (Power Boat), CAR
(Car: default), MCYCLE (Motorcycle), BALLOO (Balloon),
JEEP (Jeep), RV (Recreational Vehicle), TRUCK (Truck),
VAN (Van) and OTHER (Other).
If “OTHER” is selected, set the desired symbol code as fol-
lows;
q Push [
](MONI) to begin programming.
• 1st character blinks.
• “--” blinks at the 1st character and “--” appears at the 2nd char-
acter if no symbol is programmed previously.
w Rotate [DIAL] to select the 1st character from “\” and “/.”
e Push [](LOW) to select the 2nd digit.
r Rotate [DIAL] to select the 2nd digit character.
• A–Z (capital letters), 0–9, !, ”, #, $, %, &, ’, (, ), , +, ,, −, ., /, :,
;, <, =, >, ?, @, [, \, ], ^ and space are available for 2nd charac-
ter.