Icom ID-E880

144
11
DTMF MEMORY ENCODER
D Transmitting a DTMF memory directly
DTMF-S
z Push [FUNC] then [LOW 6(DTMF)] to turn the
DTMF memory encoder ON.
• “ ” appears in place of 100 MHz digit.
x Push [DTMF-S] to turn the DTMF memory di-
rect selection ON.
• The function indicator (microphone) lights green.
c Push the desired DTMF channel.
• “0” to “9,” “A” to “D,” “1” and “#” are available for
DTMF memory channels.
• The selected DTMF tone sequence is automati-
cally transmitted without pushing PTT.
NOTE: When no DTMF tone sequence pro-
grammed channel number is pushed, it transmits
the relative DTMF tone sequence as the manual
transmission described as at right.
v Push [DTMF-S] again to deactivate the DTMF
memory direct selection.
b Push [FUNC] then [
SET B(D-OFF)] to cancel
the DTMF memory encoder.
D Manual transmission
DTMF-S
z Deactivate the DTMF memory encoder by
pushing [FUNC] then [
SET B(D-OFF)].
x Push [DTMF-S] to turn the DTMF direct selec-
tion ON.
• The function indicator (microphone) lights green.
c Push one of “0” to “9” and “A” to “F” keys mo-
mentarily, then push the desired DTMF keys,
0–9 and A to F.
• A: [CLR A(MW)] B: [SET B(D-OFF)],
C: [ENT C(T-OFF)] D: [SQLY D(MUTE)],
E: [VOLZ 1(TONE-1)] F: [SQLZ #(16KEY-L)]
• Automatically transmits without pushing PTT.
• The first code entering may not be transmitted
due to start transmitting takes 400 msec. Thus
the DTMF code transmission starts from the 2nd
code.
v Push [DTMF-S] again to deactivate the DTMF
direct selection.