IDS X64

Section: 9
IDS X64 Installer Manual 700-398-02D Issued August 2010
28
LOCATION 14
Global Options
This location allows you to configure the global options for the X64 Alarm Panel. Table 9 shows
the available options.
NOTE:
For each enabled option, the corresponding locations that configure that option must also be
programmed for correct operation.
Table 9: Global Options Data
LED
On / Off
Action
1
ON
A user assigned to any partition may cancel the siren
OFF
Only a user assigned to the partition that triggered the siren may cancel the siren
2
ON
Enable keypad trouble beep
OFF
Disable keypad trouble beep
3
ON
Enable telephone line monitoring
OFF
Disable telephone line monitoring
4
ON
Enable keypad beep on successful reporting to the base station
OFF
Disable keypad beep on successful reporting to the base station
5
ON
Enable keypad Fire, Medical and Panic keys
OFF
Disable keypad Fire, Medical and Panic keys
6
ON
Enable the display of bypassed and stay zones when armed
OFF
Disable the display of bypassed and stay zones when armed
7
ON
Enable the siren delay
OFF
Disable the siren delay
8
ON
Enable box tamper monitoring
OFF
Disable box tamper monitoring
9
ON
Enable siren monitoring
OFF
Disable siren monitoring
10
ON
Enable bus-wired peripheral tamper monitoring*
OFF
Disable bus-wired peripheral tamper monitoring*
11
ON
Enable onboard dedicated panic – silent
OFF
Disable onboard dedicated panic– audible
12
ON
Enable low battery monitoring**
OFF
Disable low battery monitoring**
13
ON
Enable low battery cut-out**
OFF
Disable low battery cut-out**
Default values are shaded
* Option 9 in location 16 must be enabled for this to work.
** Option 12 needs to be enabled in order for option 13 to work.