The valid data range: 00h00m – 23h59m.
Partition no. is: 1-8.
Refer to section 8.3.2 Using Sub-locations to see how to scroll from one sub-location to another using the
[*] key.
If no movement is detected, while the panel is disarmed, for the period of time specified in this location
then the alarm will activate.
This function is only available if values have been programmed into locations 175 and 176.
This No Movement Medical Alarm event reports a medical event, (see location 339 if custom reporting
codes have been used).
EXAMPLE:
This may be used to monitor for elderly people who have suddenly become incapacitated and are unable
to sound the panic.
Enter a 2-digit duration in hours for each of the 8 partitions and program as a 16-digit string,
followed by the [*] key.
[INSTALLER CODE] [*] [1] [7] [4] [*] [PARTITION NO.] [*] [ALARM TIME OUT] [*]
The valid data range is: 01 – 23, with 00 to disable.
Partition no. is: 1-8.
Refer to section 8.3.2 Using Sub-locations to see how to scroll from one sub-location to another using the
[*] key.
NOTE:
If this location is disabled, then by default, locations 175 and 176 will also be disabled. This means that
even if you put values into locations 175 and 176, no movement medical alarm will not commence.
The start time can be set for when you know that the person will be awake and active.
Program the start time to start checking for movement. For example, you expect a person to be awake at
6 am, program the start time to be 06:00.
Enter 4-digit time [HHMM] for each of the 8 partitions and program as a 32-digit string,
followed by the [*] key.
[INSTALLER CODE] [*] [1] [7] [5] [*] [PARTITION NO.] [*] [HHMM] [*]
The valid data range: 00h00m – 23h59m.
Partition no. is: 1-8.
Refer to section 8.3.2 Using Sub-locations to see how to scroll from one sub-location to another using the
[*] key.
To Next Page
Loading...
