35: Switching between motor 1 and
motor 2
36: Command switches to keypad
37: Command switches to terminal
38: Command switches to
communication
39: Pre-exciting command
40: Zero out power consumption
quantity
41: Maintain power consumption
quantity
42: Source of upper torque limit
switches to keypad
43: Position reference point input
(only valid for S1, S2 and S3)
44: Disable spindle orientation
45: Spindle zeroing/local positioning
zeroing
46: Spindle zero position selection 1
47: Spindle zero position selection 2
48: Spindle scale division selection 1
49: Spindle scale division selection 2
50: Spindle scale division selection 3
51: Position/speed control switchover
terminal
52: Disable pulse input
53: Clear position deviation
54: Switch position proportional gains
55: Enable cyclic digital positioning
56: Emergency stop
57: Motor overtemperature fault input
59: Switch to V/F control
60: Switch to FVC control
61: PID polarity switchover
62: Reserved
63: Enable servo
64: FWD max. limit
65: REV max limit
66: Zero out the counter
To Next Page
Loading...
