IMO HD2-3.7A-43 - P07-Hmi

HD2 Series Inverter Function Parameter List
-177-
Function
code
Name
Description
Default
value
Modify
lower limit
P06.29
Upper limit of
HDO output
P06.27–300.0%
100.0%
○
P06.30
Corresponding
HDO output of
upper limit
0.00–50.00kHz
50.00
kHz
○
P06.31
HDO output filter
time
0.000s–10.000s
0.000s
○
P06.32
Reserved
0–65535
0
●
P06.33
Frequency reach
detection value
0–P00.03
1.00Hz
○
P06.34
Frequency reach
detection time
0–3600.0s
0.5s
○
P07––HMI
Function
code
Name
Description
Default
value
Modify
P07.00
User password
0–65535
Set it to any non-zero value to enable password
protection.
00000: Clear the previous user password and
disable password protection.
After the user password is set and takes effect,
you cannot enter the parameter menu if you enter
an incorrect password. Please remember your
password and save it in a secure place.
After you exit the function code editing interface,
the password protection function is enabled within
1 minute. If password protection is enabled,
"0.0.0.0.0" is displayed when you press the
PRG/ESC key again to enter the function code
editing interface. You need to enter the correct
user password to enter the interface.
Note: Restoring the default values may delete the
user password. Exercise caution when using this
function.
0
○
P07.01
Reserved
/
/
P07.02
Function of keys
Range: 0x00–0x27
Ones: Function selection of QUICK/JOG key
0x01
◎