IMO HD2-3.7A-43 - Editing a Parameter List

HD2 Series Inverter Basic Operation Guidelines
-42-
Level 1
Level 2
Level 3
Level 4
default
keypad
Download NonMotor func
para from keypad
Download motor func para
from keypad
MemArea2: BACKUP012
Upload local func para to
keypad
Download all func para from
keypad
Download NonMotor func
para from keypad
Download motor func para
from keypad
MemArea3: BACKUP03
Upload local func para to
keypad
Download all func para from
keypad
Download NonMotor func
para from keypad
Download motor func para
from keypad
Restore default (excl
motor para)
Sure to restore defaults
(excl motor para)?
Restore default (test
mode)
Sure to restore default (test
mode)?
Restore default (incl motor
para)
Sure to restore default (incl
motor para)?
System settings
/
/
Language
Time/date
Backlight brightness
Backlight time
Enable power-on setup
wizard
Power-on setup wizard
Keypad programming
Fault time setting
Control board programming
Up/Down key sensitivity
5.4.2 Editing a parameter list
The parameters in the parameter list in stopped state can be added as needed (through the menu of
user defined home parameters), and the list can also be edited such as "Move up", "Move down",
"Delete from the list", and "Restore default". The edit function is shown in the following.