IMO HD2-3.7A-43 - 5.4.5 Editing user defined parameters; 5.4.6 Editing parameters in parameter groups

HD2 Series Inverter Basic Operation Guidelines
-36-
interface is the main interface during power-up by default. In stopped state, parameters in various
states can be displayed. Press or to shift the displayed parameter up or down.
HD2
16:02:35
Fwd Local Ready
Set Freq
P17.00 Hz
50.00
DC Bus Volt
P17.11 V
540.0
0x0000
AboutParameter
Menu
HDIB/A/S4/3/2/1
P17.12
16:02:35
DC Bus Volt
P17.11 V
540.0
HDIB/A/S4/3/2/1
P17.12
0x0000
0x0000
RO2/RO1/HDO/Y1
P17.13
HD2Fwd Local Ready
AboutParameter
Menu
Figure 5-7 Stopped-state parameter display 1
Press or to switch between different display styles, including list display style and progress
bar display style.
HD2
16:02:35
Fwd
Local Ready
Set Freq
P17.00 Hz
50.00
DC Bus Volt
P17.11 V
540.0
0x0000
AboutParameter
Menu
HDIB/A/S4/3/2/1
P17.12
16:02:35
HD2Fwd Local Ready
HomeBack
Set Freq
0.00 630.00
50.00
Hz
Figure 5-8 Stopped-state parameter display 2
The stopped-state parameter display list is user defined, and each state variable function code can be
added to the stopped-state parameter display list as needed. A function code which has been added
to the stopped-state parameter display list can also be deleted or shifted.
5.3.2 Displaying running-state parameters
After receiving valid running command, the inverter will enter running state, and the keypad displays
running state parameter with RUN indicator on the keypad turning on. In running state, multiple kinds
of state parameters can be displayed. Press or to shift up or down.
HD2
16:02:35
Output Freq
P17.01 Hz
50.00
Set Freq
P17.00 Hz
50.00
540.0
DC Bus Volt
P17.11 V
HD2
16:02:35
Set Freq
P17.00 Hz
50.00
DC Bus Volt
P17.11 V
540.0
378
Output Volt
P17.03 V
Fwd
Local Run
Fwd
Local
Run
AboutParameter
Menu
AboutParameter
Menu
Figure 5-9 Running parameter display state
Press or to switch between different display styles, including list display style and progress
bar display style.