IMO HD2-3.7A-43 - Page 194

HD2 Series Inverter Function Parameter List
-185-
Function
code
Name
Description
Default
value
Modify
acceleration/
deceleration time
2: 100Hz
Note: Valid for straight
acceleration/deceleration only
P08.22
Output torque
calculation mode
0: Calculated based on torque current
1: Calculated based on output power
0
○
P08.23
Number of
decimal points of
frequency
0: Two decimal points
1: One decimal point
0
○
P08.24
Number of
decimal points of
linear speed
0: No decimal point
1: One
2: Two
3: Three
0
○
P08.25
Set count value
P08.26–65535
0
○
P08.26
Designated count
value
0–P08.25
0
○
P08.27
Set running time
0–65535min
0min
○
P08.28
Automatic fault
reset times
Automatic fault reset times: When the inverter
selects automatic fault reset, it is used to set the
times of automatic reset, if the continuous reset
times exceeds the value set by P08.29, the
inverter will report fault and stop to wait for repair.
Interval of automatic fault reset: select the interval
time from when fault occurred to automatic fault
reset actions.
After inverter starts, if no fault occurred during 60s,
the fault reset times will be zeroed out.
Setting range of P08.28: 0–10
Setting range of P08.29: 0.1–3600.0s
0
○
P08.29
Automatic fault
reset time
interval
1.0s
○
P08.30
Reduction ratio of
droop control
This parameter specifies the variation rate of the
inverter output frequency based on the load; it is
mainly used in balancing the power when multiple
motors drive the same load.
Setting range: 0.00–50.00Hz
0.00Hz
○
P08.31
Switchover
selection for
motor 1 and
motor 2
0x00–0x14
Ones: Switchover channel
0: Terminal
1: Modbus/Modbus TCP communication
2: PROFIBUS/CANopen/DeviceNet
0x00
◎