IMO HD2-3.7A-43 - 5.5 Basic operations; 5.5.1 What this section contains

HD2 Series Inverter Basic Operation Guidelines
-39-
Set Freq
P17.00 Hz
50.00
DC bus voltage
P17.11 V
540.0
0x0000
AboutParameter
Menu
HDIB/A/S4/3/2/1
P17.12
Parameter groups
User defined parameters
State monitoring
Motor parameter autotune
Copy parameter/Restore default
System settings
Basic parameters
Motor and encoder parameters
Factory parameters
Terminal function parameters
Optional card parameters
Factory customized parameters
Parameter groups
User defined parameters
State monitoring
Motor parameter autotune
Copy parameter/Restore default
System settings
HD2
16:02:35
State monitoring parameters
Fault types
Fault recording parameters
HD2
16:02:35
Parameter groups
User defined parameters
State monitoring
Motor parameter autotune
Copy parameter/Restore default
System settings
Clear fault records
Modified parameters
HD2
16:02:35
Ensure motor nameplate parameters are set
correctly.
HD2
16:02:35
Parameter groups
User defined parameters
State monitoring
Motor parameter autotune
Copy parameter/Restore default
System settings
HD2
16:02:35
MemArea1: BACKUP01
MemArea2: BACKUP02
HD2
16:02:35
Parameter groups
User defined parameters
State monitoring
Motor parameter autotune
Copy parameter/Restore default
System settings
HD2
16:02:35
Parameter groups
User defined parameters
State monitoring
Motor parameter autotune
Copy parameter/Restore default
System settings
HD2
16:02:35
Language
Time/date
Backlight brightness
Backlight time
MemArea3: BACKUP03
Restore default (test mode)
Fwd
Local Ready
Fwd
Local Ready
Fwd
Local Ready
Fwd
Local Ready
Fwd
Local Ready
Fwd
Local Ready
Fwd
Local Ready
Fwd
Local Ready
Enable power-on setup wizard
Power-on setup wizard
Customize Home parameters
Restore default (incl motor para)
Restore default (excl motor para)
P00.00: Speed Ctrl Run Cmd
P00.02: Comm Cmd Channel
P00.03: Max Output Freq
P00.04: RunFreq Up Limit
P00.05: RunFreq Low Limit
P00.01: Run Cmd Channel
16:02:35 Fwd Local Ready
HD2 16:02:35 Fwd Local Ready HD2 16:02:35 Fwd Local Ready HD2
16:02:35 Fwd Local Ready HD2
16:02:35 Fwd Local Ready HD2
Back Home SeleBack Home Sele
Back Home Sele
Back Home Sele
Back Home Sele
Back Home Sele
Back Home Sele
Back Edit Sele
Back Edit Sele
Back Edit Sele
Back Home OK
Back Home Sele
Figure 5-13 Enter/exit menu diagram 2
The keypad menu setup is shown as below.
Level 1
Level 2
Level 3
Level 4
Parameter groups
Basic
parameters
P00: Basic Function
P00.xx
P01: Start/stop control
P01.xx
P03: Motor1 Vector Ctrol
P03.xx
P04: V/F Control
P04.xx
P07: HMI
P07.xx