Intamsys FUNMAT PRO 310 - Material Unloading

82 pages

Save Page as PDF

To Next Page

To Previous Page

Fig. 4.17 Material Loading Process

4.4.3 Material unloading

The material unloading process is similar to loading. Press the "Unload" button and unload the

material step by step according to the wizard tips.

Main Page

Table of Contents2
Service and Support6
Service6
Safety Instructions6
Hazard Type6
Areas with Potential Safety Hazard7
Safety Door Lock8
Environmental Requirements9
Setting and Installation10
General Information10
Tools that Come with the Printer10
Prepare Relevant Equipment for Installation10
Check the Printer Nameplate11
Printer Preparation11
Unpack11
Remove Accessories12
Unbuckle X-Axis and Y-Axis12
Startup13
Installation of Printing Build Plate14
System Components15
Printer Overview15
Top Door and User Operation Interface16
Printing Chamber Components17
Independent Filament Box17
X/Y Axis Components19
Z-Axis Components22
Hot Bed Components23
User Interface24
Overview24
Status Bar24
Navigation Bar25
Display Area26
Main Interface26
Loading Print Files27
Main Status Area28
Auxiliary Status Area29
Control Area29
Queue30
Materials31
Material Selection32
Material Loading33
Material Unloading34
Material Database Management35
Tools37
Axis Control38
Calibration39
Parameter Settings49
Settings50
Device Information50
Wireless Network Settings51
Wired Network Settings52
Camera Settings52
Remote Print53
Motor Enabling54
Screen Lock Password Settings55
Other Interfaces56
Warning Prompt56
Resume Print56
Command Line57
Operate Printer58
Startup and Shutdown of Device58
Power on the Printer58
Power off the Printer59
Preparation of Print Materials59
Nozzle Replacement and Material Change62
Nozzle Replacement62
Material Change before Printing63
Pause to Change Material63
Supply Filament after Out-Of-Material Warning64
Basic Printing Operations64
Prepare Printer64
Import Print File to the Printer65
Load the Print File66
Printing Process67
Printing Parameter Settings68
Printing Alarm69
Pause Printing69
Stop Printing70
After Completion of Printing70
Locking of Front Door and Top Cover71
Printer Status72
1Temperature Status72
Software Version72
Maintenance73
Inspection before each Printing73
Inspect the Printing Platform73
Clean the Printing Chamber73
Inspect the Nozzle73
Maintenance after each Printing74
Clean the Printing Build Plate74
Clean the Nozzle74
Clean the Chamber74
Regular Maintenance74
Clean Feeding Gears of the Extruder74
Maintenance of Moving Parts75
Maintenance of Chamber Filter77
Maintenance and Replacement of Feeding Pipe77
Others79
Troubleshooting80

Intamsys FUNMAT PRO 310 - Material Unloading

Table of Contents

Other manuals for Intamsys FUNMAT PRO 310

Related product manuals