Intamsys FUNMAT PRO 310 - Stop Printing; After Completion of Printing

64
pause or you can use this button to manually pause it.
5.4.7.1 Automatic pause
1. When an orange alarm is detected (see 8.1 for the orange alarm list), the automatic pause
command will be sent.
2. After the path in the cache is completed, the Z-axis platform is slightly lowered, then the
extruder resets, the heating of the nozzle stops while an alarm dialog box pops up, indicating the
reason for pause;
3. You need to correct the corresponding error first, then click the "Clear" button to clear the
alarm;
4. To restore printing, press the "Start" button on the main interface, and a restoration command
will be sent to the printer to instruct it to restore printing.
5.4.7.2 Manual pause
1. Click the "Pause" button to manually pause the printer;
2. After the path in the cache is completed, the Z-axis platform is slightly lowered, then the
extruder resets, and the heating of the nozzle stops;
3. To restore printing, press the "Start" button on the main interface, and a restoration command
will be sent to the printer to instruct it to restore printing.
5.4.8 Stop printing
After a print task is started, the "Stop" button in the main interface is activated. The printer can
automatically stop or you can use this button to manually stop it:
5.4.8.1 Automatic stop
When a red alarm is detected (see 8.1 for the red alarm list), the printer will automatically stop;
After the printer receives the stop command, the heating of nozzle, platform and chamber will be
disabled, and XY resets.
5.4.8.2 Manual stop
Click the "Stop" button to manually pause the printer. When the printer receives the stop command,
a dialog box for confirming or canceling the stop will pop up. Press "OK" to stop the printer. After
the printer receives the stop command, the heating of nozzle, platform and chamber will be disabled,
and XY resets.
5.4.9 After completion of printing
After prototyping is completed, the print head resets and stops, the printing platform automatically
descends to the bottom and the screen will show 100% print progress, indicating that the printing
prototyping has been completed. The model needs to be removed from the printer together with the
build plate.